Safety data sheet

Material Safety Data Sheet
Report No.: TCT160301M005 Page 5 of 9
Hotline: [phone] Tel: [phone] Fax: [phone] http://www.tct-lab.com
NFPA Health: 0 Flammability: 0 Instability: 0
Section 6- Accidental Release Measures
Personal Precautions, protective
equipment, and emergency procedures
Restrict access to area until completion of
clean-up. Do not touch the spilled material. Wear
adequate personal protective equipment as
indicated in Section 8.
Environmental Precautions Prevent material from contaminating soil and
from entering sewers or waterways.
Methods and materials for Containment
Stop the leak if safe to do so. Contain the spilled
liquid with dry sand or earth. Clean up spills
immediately.
Methods and materials for cleaning up Absorb spilled material with an inert absorbent
(dry sand or earth). Scoop contaminated
absorbent into an acceptable waste container.
Collect all contaminated absorbent and dispose
of according to directions in Section 13. Scrub
the area with detergent and water; collect all
contaminated wash water for proper disposal.
Section 7- Handling and Storage
Handling
The battery should not be opened, destroyed or
incinerate, since they may leak or rupture and
release to the environment the ingredients that
they contain in the hermetically sealed container.
Do not short circuit terminals, or over charge the
battery, forced over-discharge, throw to fire.
Do not crush or puncture the battery, or immerse in
liquids.
Storage
Avoid mechanical or electrical abuse. Storage
preferably in cool, dry and ventilated area, which is
subject to little temperature change. Storage at
high temperatures should be avoided.
Do not place the battery near heating equipment,
nor expose to direct sunlight for long periods.
The voltage for a long time storage shall be
3.8V~4.35V range.
Other Precautions
The battery may explode or cause burns, if
disassembled, crushed or exposed to fire or high
temperatures. Do not short or install with incorrect
polarity.