User manual

4 © MARMITEK

2. CONTENT OF THE PACKING

MegaView60 MegaView61

1x transmitter (HDMI Transmitter) 1x transmitter (HDMI Transmitter)

1x receiver (HDMI Receiver) 1x receiver (HDMI Receiver)

1x Power adapter 1x Infrared receiver

1x User manual 1x Infrared extender cable with 2 IR LEDs

1x Power adapter

1x User manual

3. CAT5E/CAT6 CABLE REQUIREMENTS

• UTP-, FTP- or STP-cable

• 24AWG or lower

• Solid twisted pair

• 100 ohm at 1MHz

• RJ-45 jack according to EIA/TIA T568B standard

Instead of CAT5e cable, CAT6 cable may also be applied (this offers better quality). Use a

‘solid twisted pair CAT-5e or CAT-6 cable’ in order to optimise transfer quality.

4. INSTALLATION

In order to ensure that the system is working properly you are advised to check the set-up

with short CAT-5e/6 cable lengths first.

1. Switch off all appliances before you start connecting.

2. Connect the HDMI source (HD-DVD player, blu-ray disc player, HD set-top box, game

console, etc.) to the MegaView60/61 transmitter [1], using an HDMI cable (not provided).

3. Connect the MegaView60/61 receiver to the appliance shown [2] (e.g. HDTV or projector),

using an HDMI cable (not provided).

4. Use two CAT5e/6 Ethernet cables to connect the MegaView60/61 transmitter with the

MegaView60/61 receiver [3&4].

*The RJ45 plug on these cables must be connected according to EIA/TIA T568B standard,

see attachment page 39.

Make sure that the CAT5e/6 cable and the transmitter and receiver connections (CAT5e-1 en

CAT5e-2) correspond to one another.

CAT5e-2

CAT5e-1

HDMI

HIGH SPEED CAT5e/6 EXTENDER

HDMI Transmitter

HDMI Rece iv er

3 & 4

HDTV

Blu-ray player

MediaCenter PC

HD Settop box

IR Extender

IR Receiver