Instructions

- 8 -
When changing the port, the peripheral equipment could not
shift to the new port, and run smoothly. Under this situation,
please un-install the equipment and re-install again.
3.4 How to Set Up the RS232 Serial Device
Follow the following steps to connect your RS232 Serial Device
(ie: Modem) to the USB port of your PC:
1. Turn off your Serial Device (ie: Modem). Plug the DB 9P
connector of the USB-Serial cable AU0002E into your Modem.
Turn on the Modem afterwards.
2. Turn on your computer and plug in the USB connector of the
USB-Serial cable into the USB port.
3. If you have already installed a Modem device before, click
Start, Settings, Modems. Open Modems Properties, select the
Modem, and click Properties. In General tab, please change
the Port value to USB to Serial Port (COM3).
4. After finishing these processes, you can use USB to Serial
Bridge Cable to
connect RS232
Serial 56K FAX
Modem and execute
the Dial-up function
to connect Internet,
and send the FAX
with the FAX software
(ie: Microsoft FAX)
properly.