Operation Manual

Operation

Switching On Your Wine Cooler

1. The internal temperature of the wine cooler is

controlled by a thermostat. There are four settings

MIN, NORMAL, MAX and SUPER.

2. Before connecting the wine cooler to the mains

socket, make sure that the thermostat control dial,

located at the rear of the wine cooler on the right

hand side is set to MAX. Connect the mains cable

to the mains socket.

3. After the wine cooler has been on for 20 minutes

adjust the thermostat control dial to NORMAL.

This is the recommended setting when operating

at normal room temperature (between 16°C and

32°C).

4. The wine cooler may not operate at the correct

temperature if it is in a particularly hot or a

particularly cold room, or if you open the door

often.

5. If you are concerned that the wine cooler is not

being kept cold enough and wish to check the

temperature you will need a special fridge/freezer

thermometer. You may also need a hygrometer to

check the humidity of your wine cooler. These are

available from most supermarkets and hardware

shops.

Place the thermometer and hygrometer on the

middle shelf of the wine cooler, where it can be

read easily. Leave overnight, the temperature in the

wine cooler should be between 5°C and 20°C and

the humidity in the wine cooler should be between

50%-80% RH depending on the type of wine.

THERMOSTAT CONTROL DIAL

NORMAL

SUPER

MIN

MAX

In the MIN position the wine cooler will

not operate, but the power supply remains

connected.

LWC32B10_IB_final110309.indd 9 09/03/2011 11:43 AM