Operation Manual

Remote deactivation

 The answering machine is activated.

 Enter your telephone number

 The answering machine is triggered (depending on the settings) and plays the

recording corresponding to the mode set (recorder or answering machine only)

 While the message is playing, press key * on your telephone, then compose your

4-figure remote consultation code (0000 by default)

 A short beep is emitted

 Press key 9 to deactivate the answering machine

 Hang up

7 – Memory full

The answering machine possesses a recording capacity of 15 minutes maximum.

Once the limit has been reached during the recording of a message, the answering

machine immediately stops the call and hangs up.

If you receive a call when the answering machine memory is already full, the recorded

message played invites your correspondent to call back later.

"REP MEM SAT" is then displayed on the handset screen

To free up space on the answering machine, you must listen to your new messages and

delete them as indicated in chapters "Listening to messages" and "Deleting all

messages and memos".

Answering machine settings

For all answering machine settings, your handset must be in idle mode (no tones)

1 – Selecting the answering machine mode (Recorder/Answering

machine only)

There are two answering machine modes:

Recorder mode: Allows your correspondent to leave a message

Answering machine only: Does not allow your correspondent to leave a message, but

invites them to call back later. (This mode is automatically activated when the memory

is full)

Enter the menu and use the DOWN key to select the "ANS MACHINE"

Select "TAM SETTINGS"

Select "ANSWER MODE"

Choose between "ANSWER ONLY" and "ANS & REC", a beep will

confirm your choice