Quick Start
Table Of Contents
- Trademarks
- Got everything?
- Installation guide
- Getting Started
- Warning on using the phone while driving
- Listening safety
- Electromagnetic waves safety information (SAR)
- Safety and care information
- Epilepsy warning
- Technical informations
- Recycling
- Simplified EU declaration of conformity
- The warranty scope of application
4
• Insert the SIM card correctly into the relevant card slots (see figure below). Please respect the direction of
card insertion.
• The two SIM slots use a Nano-SIM card.
WARNING: The 3G/4G function can only be used on one SIM card.
3. Inserting a MicroSD
It is possible to increase the internal memory of the Smartphone device with a MicroSD card. (Maximum 32GB
MicroSD card).
• Switch off the phone and remove the rear cover and battery.
• Insert the memory card into the relevant slot.
• Then replace the battery and cover.
CAUTION: Inserting or removing a SIM card or a MicroSD card requires the Smartphone to be completely switched
off.
4. Charging the battery
Installing the battery:
• Remove the rear cover of your Smartphone.
• Insert the battery ensuring that the image shown here is facing you.
• Replace the rear cover of the Smartphone.
CAUTION: Risk of explosion if battery is replaced by an incorrect type.
Model: FHPV395386P (Li-Polymer – 3,85V – 3000mAh)
To replace the battery, please enquire with the after-sales service of your dealer.
Dispose of used batteries according to the instructions.
Charging the battery:
• To charge the battery, connect the USB cable (supplied) to the USB port of
your Smartphone and the other end to the mains adaptor (supplied). Then
connect the mains adaptor to a power outlet.
• The battery charge icon illuminates during charging and indicates the charge status.
• When the battery is fully charged, you can disconnect the USB cable from the device then from the
power outlet.
IMPORTANT:
• The Smartphone is only recharged via its USB port.
• Ensure your Smartphone is fully discharged before charging it for the first time.
• The battery must be charged for at least 5 to 8 hours when first charged.
• After a long period without use, It should be necessary to do many cycles of charging / discharging to
obtain maximum power capacity
Note: You can use the device when it is being charged. In this case, the battery may take longer to charge fully.
Safety information for charging the battery:
• To recharge the battery, only use the mains adaptor supplied with your device. Do not use any other
power supply or electrical device.
• The power outlet to which the device is connected must be near the equipment and must always be
easily accessible.