Quick Start
Table Of Contents
- Trademarks
- Got everything?
- Installation guide
- Getting Started
- Warning on using the phone while driving
- Listening safety
- Electromagnetic waves safety information (SAR)
- Safety and care information
- Epilepsy warning
- Technical informations
- Recycling
- Simplified EU declaration of conformity
- The warranty scope of application
4
3. Inserting a MicroSD
It is possible to increase the internal memory of the Smartphone
device with a MicroSD card. (Maximum 32GB MicroSD card).
• Switch off the phone and remove the rear cover and
battery.
• Insert the memory card into the relevant slot.
• Then replace the battery and cover.
CAUTION: Inserting or removing a SIM card or a MicroSD card
requires the Smartphone to be completely switched off. The SIM
slot 2 is shared with the MicroSD slot, so you use a card (Nano SIM
or microSD) at a time.
4. Charging the battery
Installing the battery:
• Remove the rear cover of your Smartphone.
• Insert the battery ensuring that the image shown here is facing you.
• Replace the rear cover of the Smartphone.
CAUTION: Risk of explosion if battery is replaced by an incorrect type.
Model: PH HS365874AR (Li-ion – 3,8V – 2150mAh)
To replace the battery, please enquire with the after-sales service of your
dealer.
Dispose of used batteries according to the instructions.
To replace the battery, please enquire with the after-sales service of your
dealer.
Dispose of used batteries according to the instructions.
Charging the battery:
• To charge the battery, connect the USB cable (supplied) to the USB
port of your Smartphone and the other end to the mains adaptor
(supplied). Then connect the mains adaptor to a power outlet.
• The battery charge icon illuminates during charging and indicates the
charge status.
• When the battery is fully charged, you can disconnect the USB cable from the device then from the
power outlet.
IMPORTANT:
• The Smartphone is only recharged via its USB port.
• Ensure your Smartphone is fully discharged before charging it for the first time.
• The battery must be charged for at least 5 to 8 hours when first charged.
• After a long period without use, It should be necessary to do many cycles of charging / discharging to
obtain maximum power capacity
Note: You can use the device when it is being charged. In this case, the battery may take longer to charge fully.
Safety information for charging the battery:
• To recharge the battery, only use the mains adaptor supplied with your device. Do not use any other
power supply or electrical device.