User Manual

4
Emergency Wall Communicator v3.2
Notes:
• Youhaveupto45secondsafterpushingtheREDCodeLearnbutton
on the Base unit to get the EWC to enter “Pendant Learning”.
• Learning additional Pendants or EWCs does not erase previously
learned Pendants or EWCs.
• TheBaseunitwillautomaticallyexitthePendantlearningmodeafter
several seconds or if Pendant learning failed.
• Onlyacombinedtotalof9PendantsandEWCscanbelearnedtoa
Base unit. If a Pendant has been lost or replaced, erase all the Pendants
andrelearnallcurrentPendantsandEWCs.(Seenextparagraph).
At a later point in time, you might want to erase your previously learned
pendants. You can erase all previously learned Pendants and/or EWCs by
simply holding down the red Code Learn button at the back of the Base
unitfor8-10seconds.Youwillheartheconrmationof“PreviousPendant
Codes Erased” from the Base unit. After that, you can program a new
Pendant to the Base unit following the steps above as desired.
Mounting the Product.
You have two choices to mount the product to the wall. You can use the two
screws provided - or you can use the special Velcro style fastener provided.
If using the screws - Attach the mounting plate to the wall. If using the
Velcro - make sure the surfaces are clean and dry before mounting.
Battery Check:
The 4 AAA alkaline batteries should power the unit for over one year in
standby mode. When the EWC is used - there are several hours of talk
time on fresh batteries. We recommend replacement of the batteries every
6 months, just like a smoke detector.
TheEWChasabuilt-inbatterytestertoallowyoueasyconrmationofthe
status of the batteries. When you press the small Gray button on the EWC,
a voice announcement will inform you of the condition of the battery. One
of the following messages will be heard: