User Manual
v3.2 Emergency Wall Communicator 3
Installing the Battery
Slide the battery cover to the left to unlatch the cover
Install the 4 AAA alkaline batteries - noting the polarity on the inside of the
battery cover. The spring contacts are meant to touch the negative side of
the batteries. Close the battery cover and latch to lock cover.
Learning the EWC to the Base unit of Your PERS System.
Note: Throughout this manual, EWC will refer to the Emergency Wall
Communicator; Pendant will refer to a hand-held pendant used by the
Personal Emergency Response System (PERS) and Base will refer to the
base unit of the PERS system.
On the Base Unit:
1. Push and release the RED Code Learn button on the back of the
Base unit. (Use the tip of the screwdriver or a ball-point pen to reach
through the case). You will hear a voice prompt “Pendant Learning”
On the EWC:
2. PUSH the RED Help button and then the GRAY Test button simul-
taneously –HOLD both buttons for a few seconds until you hear
“Pendant Learning” from the EWC - then release both buttons.
• If“BaseandPendantoutofRange”isheardfromtheEWC,stop
- wait 30 seconds and start at step #1 again.
3. When Pendant learning has been successful you will hear “Pendant
Code Learned” and then it will announce the mode of the Base unit.