User's Manual

Step-by-Step Installation Guide
Confirm Accessories in Kit
1
Waterproof pendant
Wrist Strap
(Shown with waterproof
pendant)
Lanyard
Test the Unit
3
Red Code Learn button
Teach the Pendant to the System
2
On the Base Unit
a. PUSH and RELEASE the RED Code Learn button on back of base
unit. You will hear a voice prompt, “Pendant Learning.”
On the Pendant
a. PUSH the GRAY Emergency button until you hear, “Pendant
Learning” from the base. Then, release the button on the
pendant.
i. If you hear, “Base and Pendant out of Range,” STOP - wait 30
seconds and begin step 2 again.
b. When pendant learning has been successful, you will hear,
“Pendant Code Learned,” and then it will announce the call setting
that the base is set to Programming Mode or Emergency Call
Mode.
*NOTES:
Erasing all previously learned pendants – hold down the (Red) Code Learn
button for 8 seconds. You will hear the confirmation of “Erasing All Pendants, All
Pendants Erased” from the base unit. Now you can re-teach pendants starting at
Step #2.
Lost Pendants – If a pendant has been lost, follow the note for “Erasing all
previously learned pendants” and then re-teach all of the pendants starting at Step
#2.
Teaching additional pendants - does not erase previously learned pendants.
Exiting Learning Mode - Base will automatically exit the pendant learning mode
after successfully learning the pendant or after the base announces “Pendant
Learning Failed”.
Up to 9 waterproof pendants can be taught to each base.
Place call to Emergency Operator:
a. Push the GRAY EMERGENCY button for 2 seconds on Pendant. (The
RED LED on the pendant should turn ON for 1 second.)
b. You should hear a dial tone, dialing, and then communication tones
between the CaretakerSentry and central station. Several seconds
later the operator should answer the call.
c. Talk normally to the base unit – just like into a speaker phone.
d. At the end of the conversation, the CaretakerSentry should automatically
hang-up – if not, push the CANCEL button for 1 second.
Performing a System Test
a. PUSH and HOLD the CANCEL button for 8-10 seconds to enter “System Check”
b. Push the GRAY EMERGENCY button for 2 seconds on Pendant.
(The RED LED on the pendant should turn ON for 1 second.)
c. Listen for the voice prompt from base unit:
i. “All Systems are OK – Battery is OK” is heard if the system is correctly installed.
ii. If any other voice prompt is heard, the unit will describe the problem.
d. Push and release the CANCEL button for 1 second to exit Test Mode.
(The unit will automatically exit in 3 minutes.)
e. We recommend that you perform this System Test weekly.