User's Manual

16
LifeSentry
®
v0.3
• Only 4 Pendants can be learned. If Pendants have been lost or replaced,
we recommend you erase all pendants and re-learn all current Pendants.
You can erase all previously learned pendants (and Emergency Wall Com-
municators) by simply holding down the red Code Learn button at the back
of the Base unit for 8 seconds. You will hear the conrmation of “Previous
Pendant Codes Erased” from the Base unit. After that, you can program a
new Pendant to the Base unit following the steps above as desired.
Out of Service Storage or Transportation: When storing the Base unit
-or taking it on a trip - or sending it in for repair - it is recommended that
you remove one or all of the AA rechargeable batteries from the base unit
so that the “Running on battery power” announcement for the next 24 hours
doesn’t drive the postmaster crazy. Remember to re-install the 4 batteries
in the Base unit when it is put back in service.
TROUBLESHOOTING GUIDE
What if I can’t get the system to work?
Step 1 – Push the gray RESET button with a pen at the back of the base
unit (next to the power cord). Check the system. If it is now working skip
the remaining steps.
Step 2 – Check the PENDANT.
What to do:
Press the Gray Battery Test / System Check button on the
back of the Pendant.
What to expect:
A voice should announce the condition of the battery.
A light on the front of the Pendant will come on.
If nothing happens, the most likely cause is that the battery is dead or has
been installed backwards.
If the Pendant says “Battery ok”, go on to step 3.
Step 3 – Check the connections on the BASE UNIT
What to do:
Make sure the AC Adapter is plugged into a live AC outlet