User's Manual
v0.3 LifeSentry
®
15
Adding Additional Pendants to the System.
The system comes with one Pendant. If you want to add additional pendants
or the Emergency Wall Button accessory to your system - follow the directions
here. If not, skip this section. NOTE: You can learn a total of 4 Pendants and
Emergency Wall Buttons to the system.
The Pendant’s unique ID code should already be learned into the Base unit
when it came from the factory. You can add additional Pendants (up to 4)
to the system by simply teaching each pendant’s ID code to the Base unit.
To program a new Pendant or Emergency Wall Button to the Base unit:
On the Base Unit:
1. Push and release the RED Code Learn button on the back of the base
unit. You will hear a voice prompt “Pendant Learning”
On the Pendant:
2. PUSH the Gray Battery Test button and the Blue Panic button simulta-
neously. HOLD both buttons until you hear “Pendant Learning” from
the pendant - then release both buttons on the pendant.
• If “Base and Pendant out of Range” is heard from the pendant,
STOP - wait 30 seconds and start at step #1 again. (Note that the
panic button is RED on the Emergency Wall Switch)
3. When Pendant Learning has been successful you will hear “All Systems
are OK”
• If Pendant learning failed - STOP - wait 30 seconds and start at step
#1 again.
Notes:
• You have up to 45 seconds after pushing the RED Code Learn button
on the base unit to get the pendant to enter “Synchronizing Mode”.
• Teaching additional pendants does not erase previously learned pen-
dants.
• The base unit will automatically exit the pendant learning mode after
several seconds or if Pendant Learning Failed.
• If you hear the voice prompt “Base and Pendant Out of Range” or
“Pendant Learning Failed” an error has occurred, wait 30 seconds for
the base to reset and repeat steps 1 & 2.
• When more than 1 pendant is learned to the base, the base unit will
announce the pendant number when doing testing like the battery test.