User's Manual

14
LifeSentry
®
v0.3
Key to LEDs on Product:
Here is the key for the LEDs on the Base unit and the Pendant:
BASE RED LED functions:
Off: No AC power/No Back-up Battery Power
Solid: AC power
Flashing: Running on Battery Back-up
BASE GREEN LED functions:
Off: Standby
Solid: Dialing/Talking or Learn Mode
Flashing: Pendant Learning or Low Pendant battery
PENDANT LED (single RED LED) Functions:
Off: Standby
Solid: Dialing or Talking
Flashing: Pendant Learning
EMERGENCY WALL COMMUNICATOR LED (single RED LED)
Functions (Note - this is an optional accessory):
Off: Standby
Solid: Dialing or Talking
Flashing: Pendant Learning
Periodic Testing / Maintenance
It is highly recommended that you preform a full System Check (see page
12) at least twice a month. This will conrm that the Pendant battery is in
good condition and that the Base unit is able to get a dial tone.
Replacing Batteries: Replace the Base unit batteries every 2 years - or as
needed. Be sure to purchase NiMH AA batteries with 2,400 mAH or greater
capacity. A set of batteries in good condition and fully charged will supply
24 hours of back-up in the event of a power outage. You can test this by
unplugging the AC Adapter and hearing the voice prompts. The Base unit
will announce “Running on battery power” once every 5 minutes for 15
minutes - then once very 30 minutes until the batteries are depleted.