User's Manual

6
FreedomAlert
®
v9.5
Installing the Batteries
Pendant - small white batteries. The Pendant requires one of the white
Li-Ion (Lithium Ion) batteries at any given time. The pendant should be able
to run up to 2 months on a fully charged battery. The second battery is to be
charging in the Base unit when not being used in the Pendant. There is no
problem of over charging while in the base charger.
To install the battery - rotate the battery cap
90’ counter-clockwise. Pull the battery cap
straight up to remove. Install the battery
with the positive side up facing the cap.
Re-install the cap by aligning the cap as
per the diagram to the left. Then push the
cap back down and rotate 90’ clockwise to
lock in place.
When the battery is first installed into the
Pendant - you will hear an aubile announc-
ment of the battery status: “Battery is ok”;
“Battery is low” or “Replace battery now”.
If the battery is fully discharged when you
get your unit - you may not hear anything
- at which point you will need to charge
one of the batteries up overnight in the
base charger before you will be able to
use the system.
You can check the battery status at any
time by simply pushing the gray battery
test button on the back of the Pendant for a second.
NOTE: These white batteries are very special batteries that are not available
at your local store. See Specification on page 28 for more details, or contact
LogicMark to purchase replacement batteries.
FreedomAlert instructions v9-5 E6 6 10/24/2009 11:01:58 PM