User's Manual

v9.5 FreedomAlert
®
15
At a later point in time, you might want to erase your previously learned
pendnats. You can erase all previously learned pendants by simply holding
down the red Code Learn button at the back of the Base unit for 8 seconds.
you will hear the confirmation of “Previous Pendant Codes Erased” from
the Base unit. After that, you can program a new pendant to the base unit
following the steps above as desired.
Operating the FreedomAlert:
Operating the Pendant. The Pendant is simple in operation - having one
main Blue button - and a smaller Gray button on the back.
The Blue button on the front is the main button to push for a full second to
initiate a call. Once this button is pushed the call proceeds forward to the
‘Friends’ list and or 911 depending on the slide switch setting on the back
of the Base unit.
FreedomAlert instructions v9-5 E15 15 10/24/2009 11:02:00 PM