User Guide

Product User Guide | 3
HiTemp140 Series
PRODUCT USER GUIDE
Device Operation (cont’d)
Set Password
To password protect the device so that others cannot
start, stop or reset the device:
1. In the Connected Devices panel, click the device desired.
2. On the Device Tab, in the Information Group, click
Properties. Or, right-click the device and select
Properties in the context menu.
3. On the General Tab, click Set Password.
4. Enter and confirm the password in the box that
appears, then select OK.
Device Maintenance
Battery Replacement
Materials: ER14250MR-145 Battery
1. Unscrew the bottom of the logger
and remove the battery.
2. Place the new battery into the logger.
Note the polarity of the battery. It is
important to insert the battery with
positive polarity pointing upward
towards the probe. Failure to do so
could result in product inoperability
or potential explosion if exposed to high temperatures.
3. Screw the cover back onto the logger.
Recalibration
MadgeTech recommends annual recalibration. To send
devices back for calibration, visit
madgetech.com.
Note: This product is rated for use up to 140 °C
(284 °F). Please heed the battery warning. The
product will explode if exposed to temperatures
above 140 °C (284 °F).
Ordering Information
HITEMP140-1 PN 900140-00 High Temperature Data Logger with a 1 inch probe
HITEMP140-2 PN 900153-00 High Temperature Data Logger with a 2 inch probe
HITEMP140-2-TD PN 900165-00 High Temperature Data Logger with a 2 inch transitional diameter probe
HITEMP140-5.25 PN 900173-00 High Temperature Data Logger with a 5.25 inch probe
HITEMP140-5.25-TD PN 900180-00 High Temperature Data Logger with a 5.25 inch transitional diameter probe
HITEMP140-7 PN 900198-00 High Temperature Data Logger with a 7 inch probe
IFC400 PN 900319-00 Docking station with USB cable
IFC406 PN 900325-00 6 Port, Multiplexer docking station with USB cable
ER14250MR-145 PN 900097-00 Replacement battery for the HiTemp140