Product Info

Report No: CCISE191202301-V01
Shenzhen Zhongjian Nanfang Testing Co., Ltd. Project No.: CCISE1912023
No. B-C, 1/F., Building 2, Laodong No.2 Industrial Park, Xixiang Road,
Bao’an District, Shenzhen, Guangdong, China
Telephone: [phone] Fax: [phone], E-mail: [e-mail] Page 33 of 171
13.2 WCDMA Conducted Power
The following tests were conducted according to the test requirements outlines in 3GPP TS 34.121 specification.
A summary of these settings are illustrated below:
HSDPA Setup Configuration:
a. The EUT was connected to Base Station Rohde & Schwarz CMU200 referred to the Setup
Configuration.
b. The RF path losses were compensated into the measurements.
c. A call was established between EUT and Base Station with following setting:
i. Set Gain Factors (βc and βd) and parameters were set according to each
ii. Specific sub-test in the following table, C10.1.4, quoted from the TS 34.121
iii. Set RMC 12.2kbps + HSDPA mode.
iv. Set Cell Power = -86 dBm
v. Set HS-DSCH Configuration Type to FRC (H-set 1, QPSK)
vi. Select HSDPA Uplink Parameters
vii. Set Delta ACK, Delta NACK and Delta CQI = 8
viii. Set Ack-Nack Repetition Factor to 3
ix. Set CQI Feedback Cycle (k) to 4 ms
x. Set CQI Repetition Factor to 2
xi. Power Ctrl Mode = All Up bits
d. The transmitted maximum output power was recorded.
HSDPA Sub-test setup configuration