™ 7-IN-1 WIRELESS 6-DAY FORECAST WEATHER STATION WITH WI-FI,® EVERLASTING SOLAR CELL & ULTRA-WIDE DISPLAY USER GUIDE LOWSC715FWB10
Thank you for purchasing the Logia 7-in-1 Wireless 6-Day Forecast Weather Station with Wi-Fi , Everlasting Solar Cell, and Ultra-Wide Display. This User Guide is intended to provide you with guidelines to ensure that operation of this product is safe and does not pose risk to the user. Any use that does not conform to the guidelines described in this User Guide may void the limited warranty. ® Please read all directions before using the product and retain this guide for reference.
202 mm PRODUCT FEATURES PACKAGE CONTENTS 1. Wireless 7-in-1 weather sensor measures wind speed, wind direction, rainfall, UV index, light intensity, temperature, and humidity 7-IN-1 WIRELESS 6-DAY FORECAST WEATHER STATION WITH WI-FI® EVERLASTING SOLAR CELL, & ULTRA-WIDE DISPLAY 2. No calibration needed! The product is fully pre-calibrated and mostly assembled; all you need to do is install it and sync with the included display console 3.
11 11 PRODUCT OVERVIEW 1. 1.Time Time && Data, Data, Moon Moon phase, phase, Sunrise Sunrise / sunset / sunset6. 6.Sky Sky condition condition && moon moon rise rise / moon / moon setset WEATHER CONSOLE OVERVIEW 7. 7.AirAir quality quality 2. 2.Wind Wind direction direction && speed speed 8. 8.Barometer Barometer 3. 3.Solar Solar Light Light intensity intensity 9. 9.Indoor Indoor / CH / CH temperature temperature && humidity humidity 4. 4.UVUV index index 10.10.
WIRELESS SENSOR OVERVIEW 3. 3.1 1. Antenna GETTING STARTED WIRELESS 7-IN-1 SENSOR 2. Radiation shield & hygro-thermo sensor 3. Mounting base 4. Battery door 5. RESET button 9. Wind vane 7. Bubble level 11. Solar Cell 6. Transmission status LED 10. UV/light sensor 8. Rain collector 12. Wind cups 1 INSTALLATION INSTRUCTIONS SETTING UP THE WIRELESS 7-IN-1 OUTDOOR SENSOR INSTALLATION AND SETUP G STARTED ESS 7-IN-1 SENSOR 3. GETTING STARTED 3.
Step 6: Remove the solar panel protection film. INSTALL RECHARGEABLE BATTERIES : Unscrew the battery door at bottom of unit and take cable socket. 4. Connect the cable of the rechargeable battery pack (included) to the cable located in the battery compartment. : Connect the Ni-MH rechargeable battery plug to the . : Connect the Ni-MH rechargeable battery plug to the . ADJUSTING THE SOLAR CELL 1. Remove the protection film on the solar cell. Step 6: Remove NOTE: - USE ONLY the rechargeable 3.
The joint of the solar cell is labeled with different degrees (0, 15, 30 45, and 60). To place the solar cell in the right position for your location, set the solar cell to the angle that is closest to your latitude. View chart below to get an idea how you should angle your solar cell. NOTE: The weather station cannot tell you what the latitude of your location is. You will have to research your latitude before you can properly adjust the solar cell.
3.4.2 SETUP DISPLAY CONSOLE 1. Once the console power up, all the segments of the LCD will be shown. 2. The console will automatically start AP mode and show the "AP" icon on the screen, you can follow the section 6 to setup the WI-FI connection.
OUTDOOR TEMPERATURE, HUMIDITY & TEMPERATURE MPERATURE, HUMIDITY & TEMPERATURE INDEX 1 2 3 4 attery indicator Mode Setting procedure l indicator to show the signal Wind chill or windchill is the lowering of temperature due to the passing-flow of lower-temperature air.
ion section INDOOR TEMPERATURE & HUMIDITY n The indoor reading is the default mode of this console. This mode shows comfort indication and temperature/ VIEW CH sensorhumidity readings. ATURE HUMIDITY indicator& for CH sensor on ltalmode of the strength iconconsole, which humidity reading of indoor. mber on ion e reading section ND SCROLL olsection sensor icon MODE FOR OPTIONAL SENSORS sensor status section nal Thermo-Hygrometer MULTI-CHANNEL MODE FOR OPTIONAL SENSORS ction 3.2).
Severe widespread damage to vegetation 0.3 ~ 1.5 m/s ≥ 74 mph and structures. Debris and unsecured 6 ~ 11 km/h ≥ 64 knots objects are hurled about. ≥ 32.7m/s Wind can be felt on exposed 4 ~ 7 mph 2 Light breeze skin. Leaves rustle. Wind 4.3.9 BAROMETRIC PRESSURE 4 ~ 6 knot The atmospheric pressure is the pressure at any location vanes of begin to move. 1.6 ~ 3.3 m/s the earth caused ≥ 118bykm/h ≥the 118weight km/h of the column of air above it.
long-sleeved clothing. sleeved clothing, If you have to stay outdoors, make sure to seek shade. BURN TIME TABLE Low Moderate High Very high Extreme 1d on2normal 3 skin 4type, it 5 7 of UV 8 strength. 9 In10 12~16 is just a6reference general,11the darker SKY CONDITION or more radiation) itIndex takesMode to affect the skin. N/A 45UV minutes 30 minutes TIME TABLE nBURN is for sunlight detection.
protection long-sleeved Gentle 7 3 clothing. High windbreeze Wind direction 106 °F – 129 °F (41 °C °C) 2 – 54 Minute Danger Press [ /Heat INDEX ] or [ highly / MODE exhaustion likely] key to adjust the minute 8you ~mph 12have mphto stay outdoors, Third quarter INDEX 31 ~ If38 direction indicator 4.3.
TIME, DATE, AND GENERAL SETTINGS DISPLAY BACKLIGHT Press and hold the SET button for two (2) seconds to enter the setting mode. Press DOWN/INDEX or UP/ FORECAST button to adjust the setting and press SET button again to save and proceed with next step of the setting. Refer to the chart below for the order of settings. The weather console backlight can be adjusted, using the HI/LO/AUTO slider to select the appropriate brightness: • Slide to the HI position for the brighter backlight.
- Slide to the [ AUTO ] position for the auto adjust back light that according to environment light level. 5. CREATE PWL ACCOUNT & SETUP WI-FI CONNECTION OF CONSOLE The console can upload /download weather data in ProWeatherLive (PWL) cloud server through WI-FI router, you can follow the step below to setup your device. Create Your PWL Account NOTE: 1. Visit the ProWeatherLive at https://www.proweatherlive.net and notice.
SETTING UP WEATHER SERVER CONNECTION 6.3 SETUP THE WEATHER SERVER CONNECTION the information into the following interface “SETUP” page. page. Ensure all information is entered Enter the Enter information into the following webweb interface "SETUP" Ensure all information is Apply prior to to pressing pressing connect the to ProWeatherLive. entered prior totoconnect theconsole console to ProWeatherLive. SETTINGS 6.
CALIBRATION 1. You may enter or change the offset and gain values for different measurement parameters, while viewing the current offset and gain values next to the corresponding boxes. 2. Once you have completed your calibrations, press the APPLY button on the SETUP tab. 3. 6.4.1 The current offset value will update to show the value that you entered (instead of the default CALIBRATION If you want change the value, you canforenter a newparameters value in thewhile box beside number 1.value).
ate process have potential risk, which cannot guarantee 100% success. If the update fail, e above step to update again. ERY REPLACEMENT TROUBLESHOOTING tery indicator or is r the antenna icon of it indicates that the 1 sensor and/or current or(s) battery power is low Please replace with new PROBLEM SOLUTION 7-in-1 wireless sensor is not connecting. 1. Make sure the sensor is within the transmission range. 2. If it still does not work, reset the sensor, and resynchronize with console.
SPECIFICATIONS DISPLAY CONSOLE General Specifications Product type Weather/environment sensor & console Dimensions (W x H x D) 8.6″ x 7.9″ x 1.0″ (219 x 200 x 26 mm) Weight 1.4 lbs.
Resolution Accuracy 0.1 °F/0.1 °C 41.2 °F ~ 140 °F ± 0.7 °F (5.1 °C ~ 60 °C ± 0.4 °C) -3.8 °F ~ 41 °F ± 1.8 °F (-19.9 °C ~ 5 °C ± 1 °C) -40 °F ~ -4 °F ± 2.7 °F (-40 °C ~ -20 °C ± 1.5 °C) Outdoor Humidity Display & Function Specifications Note: The following details are listed as they are displayed or operate on the console. Humidity unit % Accuracy 1% ~ 20% RH ± 6.5% RH @ 77 °F (25 °C) 21% ~ 80% RH ± 3.5% RH @ 77 °F (25 °C) 81% ~ 99% RH ± 6.
The Company does not warrant that the operation of the Product will be uninterrupted or error-free. The Company is not responsible for damage arising from your failure to follow instructions relating to its use.
