Installation Guide

24
6. The console will restart once the update completes.
NOTES:
• You cannot update the Function Firmware and Wi-Fi
®
Firmware at the same time. Updates must be
installed one by one.
• Make sure the power cable remains connected during the update process.
• Make sure your PC’s wireless connection is stable.
• Once the update process starts, do not try to do anything else on your PC or on the display console.
• During the rmware update process, the console will stop uploading data temporarily. It will
reconnect to your router and resume uploading data once the update is complete. If the console
cannot connect to your router, you may need to set up the Wi-Fi
®
connection again, following the
steps on page 18.
• Once your rmware update completes, you may need to input your Weather Underground ID and
password again on the SETUP tab of the wireless interface.
OTHER CONSOLE SETTINGS AND FUNCTIONS
MANUALLY SETTING THE TIME
The display console is designed to synchronize with the internet time server to obtain the local time,
but if you want to use it without connecting to your home wireless network, you can set the time
manually. During initial setup, you will need to press and hold the SENSOR/WI-FI button for six (6)
seconds, then let the display console return to normal mode. This will put it into oine mode for you
to use it.
1. In normal operating mode while oine, press and hold the CLOCK SET button for two (2)
seconds to enter the clock setting menu.
2. Press the or buttons to adjust the time zone.
3. Press the CLOCK SET button again to make adjustments to the next setting.
4. Settings will cycle through the following options: Time Zone > DST ON/OFF > Hour > Minute >
12/24-hour Format > Year > Month > Day > M-D/D-M Format > Time Sync ON/OFF > Language.
5. Press the CLOCK SET button one nal time after adjusting all settings options to save and exit,
or the console will automatically save and exit the menu after 60 seconds of idle time.
NOTES:
• In normal operating mode, press the CLOCK SET button once to switch between date and year display.
• While adjusting settings, you can press and hold the CLOCK SET button for two (2) seconds to return
to normal mode.
MOON PHASE
The display console calculates the moon phase according to your time, date, and time zone. The table
below explains the corresponding phases and their icons for both Northern and Southern hemispheres.
Please refer to the section regarding Orienting the Wireless Weather Sensor Due South on page 25
for more information on setting up your Wireless Weather Sensor in the Southern Hemisphere.