Installation Guide

ManualsBrandsLogia ManualsGarden Center5-in-1 Indoor/Outdoor Wi-Fi Weather Station with Remote Monitoring System

INSTALLING THE BACKUP BATTERY

POWERING THE DISPLAY CONSOLE

Your display console can pair with the wireless weather sensor as well as up to seven (7) optional

wireless hygro-thermo outdoor sensors (not included).

5. The mounting location should be within 492 ft. (150 m) of the location where you will be keeping

the display console with few obstructions and relatively clear sightlines. If there are multiple walls/

levels/buildings in between the sensor and the display console, the functionality could be

compromised and you will need less space between the two.

6. Use the built-in level to make sure the sensor is parallel with the ground.

1. Remove the battery door on the rear of the console unit.

2. Insert a new button battery.

3. Replace the battery door.

NOTE: The backup battery can assist with backing up the time & date, MAX/MIN data, weather

records from the past 24 hours, alert settings, the oset value of weather data, and the sensor(s)

channel history. The built-in memory will backup router and weather server settings.

1. Connect the power cable to a wall outlet or power source and to the display console power

connection port.

2. The display console should power on, and all the segments of the LCD display screen should be shown.

3. The display console will automatically start AP mode.

DISPLAY CONSOLE SETUP

Step 4

Place the nut in the hexagon hole of the stand,

then insert the screw in other side and then

tighten it by the screw driver.

Install the wireless 5-IN-1 sensor

in an open location with no

obstructions above and around

the sensor for accurate rain

and wind measurement. Install

the sensor with the smaller end

facing the North to properly orient

the wind direction vane.

Secure the mounting stand and

clamps (included) to a post or

pole, and allow minimum 1.5m

off the ground.

1.5 meter off

the ground

Add rubber

pads before

mount on

the pole

Point to

NORTH

MOUNTING GUIDELINES

1. Install the wireless 5-IN-1 sensor at least 1.5m off the ground for better and more accurate

wind measurements.

2. Choose an open area within 150 meters from the LCD console.

3. Install the wireless 5-IN-1 sensor as level as possible to achieve accurate rain and wind

measurements.

4. Mount the wireless 5-IN-1 sensor with the wind meter end pointing to the North to correctly

orient direction of the wind vane.

A. Mounting on pole (Pole Diameter 1"~1.3")

(25~33mm)

B. Mounting on the railing