Installation Guide

11
2. Insert the nut into the hexagonal hole by the sensor and hold it in place, then insert the screw
through the other side. Use a screwdriver to tighten the screw. Do not insert the screw rst, or the
nut may not line up correctly with the designated hole.
3. Insert the bottom of the pole into the square hole on the plastic stand, making sure the arrows are
lined up as shown.
Please note that there are two dierent ways you can attach the pole to the base, depending on how you
will be mounting it outdoors. If you will be fastening the sensor directly to a railing, use the option that
positions the stand perpendicular to the sensor pole. If you will be fastening it to a pole, use the slot
that positions the base parallel to the sensor pole.
4
BATTERY AND INSTALLATION
Unscrew the battery door at bottom of unit and insert the
batteries according to the +/- polarity indicated.
Screw the battery door compartment on tightly.
NOTE:
1. Ensure the water tight O-ring is properly aligned in
place to
ensure water resistant.
2. The red LED will begin ashing every 12 seconds.
ASSEMBLY THE STAND AND POLE
Step 1
Insert the top side of the pole to the square hole of
the weather sensor.
NOTE:
Ensure the pole and sensor's indicator align.
Step 2
Place the nut in the hexagon hole on the sensor,
then insert the screw in other side and tighten it by
the screw driver.
Step 3
Insert the other side of the pole to the square hole
of the plastic stand.
NOTE:
Ensure the pole and stand's indicator align.
4
BATTERY AND INSTALLATION
Unscrew the battery door at bottom of unit and insert the
batteries according to the +/- polarity indicated.
Screw the battery door compartment on tightly.
NOTE:
1. Ensure the water tight O-ring is properly aligned in
place to
ensure water resistant.
2. The red LED will begin ashing every 12 seconds.
ASSEMBLY THE STAND AND POLE
Step 1
Insert the top side of the pole to the square hole of
the weather sensor.
NOTE:
Ensure the pole and sensor's indicator align.
Step 2
Place the nut in the hexagon hole on the sensor,
then insert the screw in other side and tighten it by
the screw driver.
Step 3
Insert the other side of the pole to the square hole
of the plastic stand.
NOTE:
Ensure the pole and stand's indicator align.