Installation Guide

WIRELESS WEATHER SENSOR SETUP

INSTALL BATTERIES

ASSEMBLE STAND AND POLE

1. Unscrew the door to the battery compartment on the underside of the main sensor unit.

2. Insert three (3) new AA alkaline batteries, making sure the polarities match up with the markings

inside the compartment.

1. Insert the top of the pole into the square hole at the bottom of the weather sensor. Ensure that the

arrow indicators are lined up as shown.

3. Replace the battery door, ensuring the watertight O-ring is properly aligned. This maintains the

water-resistant seal.

4. Replace the battery screw, making sure it is tightly fastened down. The red LED should begin

ashing every 12 seconds.

BATTERY AND INSTALLATION

Unscrew the battery door at bottom of unit and insert the

batteries according to the +/- polarity indicated.

Screw the battery door compartment on tightly.

NOTE:

1. Ensure the water tight O-ring is properly aligned in

place to

ensure water resistant.

2. The red LED will begin ashing every 12 seconds.

ASSEMBLY THE STAND AND POLE

Step 1

Insert the top side of the pole to the square hole of

the weather sensor.

NOTE:

Ensure the pole and sensor's indicator align.

Step 2

Place the nut in the hexagon hole on the sensor,

then insert the screw in other side and tighten it by

the screw driver.

Step 3

Insert the other side of the pole to the square hole

of the plastic stand.

NOTE:

Ensure the pole and stand's indicator align.