User's Manual

The Platinum Edge Mat Cutter has been aligned and calibrated at our facility before shipping. With a few
simple steps, you will be able to set up your mat cutter and begin production immediately.
Remove the Platinum Edge Mat Cutter from the box and unwrap the pieces carefully. Your Platinum
Edge should be set up on a flat, stable work table, aligned so that you can easily access the handle bar
lift and cutting head (Figure 2.1) and so squaring arm is supported by table. Follow the assembly guide
(Figure 2.2).
Figure 1
Logan Graphic Products, Inc. • 1100 Brown Street, Wauconda, IL 60084 USA • Phone [phone] Fax [phone] • www.logangraphic.com
1
Out Of Box Set Up
Above: Additional parts included
in this package: Four Allen
wrenchs, sizes 1/8”, 5/32”,
5/64” & 1/16”, Handle Bar Lift
Knob and screw, two replacement
blade packs (5 ct. each)
Figure 2.1
ASSEMBLY INSTRUCTIONS
(See page 6 for parts identification)
1. Insert Right Side Squaring Arm into Squaring Arm
Mount
2. Hook the Squaring Arm Strut onto the Strut
Bracket
3. Attach the Handle Bar Lift Knob
using the enclosed screw and
5/32” Allen wrench
1
2
3
Figure 2.2 Assembly Guide
IMPORTANT: Do not oil or lubricate the cutting head or guide rail.
Note: Be sure squaring arm is
supported by table.