Operation Manual

Iris Rev. 08 – 2009

English

Instrument calibration

Before using the instrument the following parameters must be set:

• choice of unit of measurement (metres or feet);

• Setting of the Rope_Chain function (optional sensor type CMCT-01);

Measure

R es et M e a su r e N o

U ni t s F e e t

R op e_ C h a i n O f f

E x i t

• detection of type of sensor (Standard or Project);

• gipsy diameter setting (default value 33 cm) or reduction factor (default value 57);

Standard and X.. Project series

sensor menu

Sensor Calibrat

Barb. Circ. 3 3 .0

E x i t

000 – 1500 –2000 W Project series

sensor menu

Sensor Calibrat

Red. Factor 57 . 0

E xi t

Use

Press the

(ON) key to activate controls and to switch on the display lighting. The display lighting

switches off 30 seconds after the last command given (adjustable default time – see “BkLight Time”).

Press key

(UP) to control the anchor ascending.

Press key (DOWN) to cast anchor.

When any key is released (UP or DOWN) the corresponding action is stopped.

Measurement reset

To reset the measurement count simultaneously press the (ON) and the (UP) keys for at least

three seconds.

Measurement reset may also be performed in the Measurement menu by selecting “Yes” in the Reset

Measure row.

Measure

R es et M e a su r e N o

U ni t s F e e t

R op e_ C h a i n O ff

E x i t

utomatic casting of the anchor

This function must be enabled in the Alarms and Functions menu (disabled by default).