Operation Manual

Iris Rev. 08 – 2009
English
23
Measurement menu
Measure
R es et M e a s u re N o
U ni t s Fe e t
R op e _ C h a i n O ff
E xi t
Use the (DOWN) or (UP) key to move around the parameters.
Reset Measurement
Resets the chain measurement value (0.0).
Select with
= Yes = No
Confirm with
Units
Selects the unit of measurement:
Feet/ inches
Metres / centimetres
Select with
= Feet = Metres
Confirm with
Rope_Chain
It is possible to enable the function and set
the value at which the sensor passes from
rope to chain. Setting range 0.1 - 25.0
(metres or feet). This value corresponds to
the chain length.
To obtain this function, install sensor
CMCT-01 (optional).
Select with
Set value with
Confirm with
Exit
To return to the settings menu.
Confirm with
Alarm and functions menu
Alarms & Functi
U p A l a r m 3 . 0
A u t o Do w n O f f
L o a d D e f a u l t N o
E x i t
Use the (DOWN) or (UP) key to move around the parameters.
Up Alarm
It is possible to enable the function and
establish the height at which the anchor-
winch stops; after which it is only possible to
give pulsed commands.
Settable values: 1.0 - 1.5 - 2.0…5.0 (metres
or feet).
Select with
Select value with
Confirm with
www.busse-yachtshop.de | [e-mail]