Operation Manual

Reference ID 40-55
User guide
22

Initial installation
Setting options for DVB-T reception:
If you have not selected DVB-T antenna in the list of available antennas:
Proceed to Setting options for DVB-C reception.
If a CA module is plugged in during Initial installation and if the
item Station of the special station list was selected in Extent
of station search, the routine continues with the step Supply
voltage (see right column).
If several networks are available via DVB-T, you can
decide which network you want to receive your chan-
nels from.
Select network,
OK Confirm selection.
 Proceed to next step.
 Select and adapt settings for DVB-T reception.
Network
selection
Please state from which network you wish to receive your station.
Note: The newly selected parameter must be confirmed with the button.
Freeview
other network
Network selection (DVB-T)
Back with Proceed with
OK
Please specify whether you want to search for scrambled stations too.
Note: Scrambled stations can only be received with an integrated CA module and
additional card.
DVB-T settings
Search method
Accept Logical Channel Number
Scrambled stations no yes
Channel search Frequency search
no yes
Back with Proceed with
Settings
Scrambled
stations
You can state whether coded stations are to be
searched for in the search/update.
Select yes to
save all found scrambled stations. However, these
stations can only be received in connection with a CA
module and the appropriate Smart Card.
Handling
of the CA module is described in chapter Extras,
section CA module.
Search
method
If you want to run the station search independently
of the channel grid, select Frequency search for
the search method.
Accept
Logical
Channel
Number
In various countries, digital stations (DVB-T) are
transmitted with a preset channel number per
station, known as Logical Channel Numbers (LCN).
If you select yes here, these default channel slots
will be used and the channels of the preferred signal
source will be sorted as per LCN. The stations in the
station list can no longer be shifted.
 Proceed to next step.
 Select supply voltage no / yes.
If you use a DVB-T antenna that requires a supply
voltage (active antenna) and which is not already
supplied via a power adaptor, then select yes (5V)
for the antenna’s power supply.
How to align your DVB-T antenna is described in
chapter System settings, section Connections
– Antenna DVB.
 Proceed to next step.
Please state here whether your DVB-T antenna needs a supply voltage. Antennas with an
integrated amplifier need a supply voltage on the antenna line.
Supply voltage DVB-T antenna
no (0V) yes (5V)
Back with Proceed with
Supply
voltage