Operation Manual

Reference ID 40-55
User guide
122

System settings
Connections
Setting the HiFi/AV amplifier
Sound playback via ... - HiFi/AV amplifier
The sound components wizard permits configuration of different
audio amplifiers (stereo amplifiers, surround amplifiers, analogue or
digital) with different digital audio formats (Dolby Digital, dts, MPEG,
and stereo/PCM). See the user guide of the audio amplifier for more
information.
For information on navigation within the wizard see
chapter General information on menu operation.
HOME: Call Home view.
 Mark System settings,
OK call System settings.
 Select Connections,
 go to next column.
 Select Sound components,
 Call sound components wizard.
Mark HiFi/AV amplifier or HiFi/AV amplifier or
TV speakers (switchable),
OK Confirm selection.
HiFi/AV
amplifier
Select setting when an amplifier is connected and
the TV speakers are not used.
HiFi/AV
amplifier or
TV speakers
(switchable)
Select setting when an amplifier is connected and
the TV speakers are used. In the sound mode selec-
tion the audio reproduction can then be switched
between the amplifier and the TV speakers.
 Proceed to next step.
Select whether the sound is to be transmitted
digitally or analogue to the the amplifier (see right
hand column):
digital: Proceed to Sound formats.
analogue: proceed to Type of amplifier.
... ...
Sound com-
ponents
SOUND COMPONENTS WIZARD - Sound playback via ...
Proceed with End with
Please specify here via which sound components you want to listen to your
TV sound. If you select a "Speaker system", this must be connected to the
DIGITAL AUDIO LINK socket on the back of the TV set (with an additional
adapter if necessary).
Note: The newly selected parameter must be confirmed with the
button.
TV speakers
Speaker system
HiFi/AV amplifier
Soundprojector
HiFi/AV amplifier or TV speakers (switchable)
OK
Sound
reproduction
via ...
...
Sound com-
ponents
Type of sound transmission
Please select whether the TV sound signal should be transmitted to the
HiFi/AV amplifier by a digital (via the SPDIF OUT) or analog (via the AUDIO
OUT) signal.
digital analogue
Proceed withBack with
Type of sound
transmission
Select sound formats which can be decoded with
the digital amplifier (see operating manual of the
used amplifier).
OK adopt sound formats.
 Proceed to next step.
Please select the amplifier type which is connect-
ed (surround or stereo amplifier).
 Proceed to next step.
If surround was selected for type of amplifier:
For every connected surround amplifier, select whether
the TV loudspeakers are to be used as centre speakers.
If yes, establish a connection between the centre
output of the amplifier and the CENTER IN socket of
the TV set via a cinch cable.
Attention: Do not use the centre speaker con-
nection of the amplifier, use the centre pre-amp
output instead!
Back: Finish wizard.
Sound
formats
...
Sound com-
ponents
Stereo (PCM)
dts
MPEG
Dolby Digital
Stereo (PCM)
Sound formats
Please specify, what kind of sound formats can be processed by your
HiFi/AV amplifier and mark them by the button .
Proceed withBack with
OK
...
Sound com-
ponents
Amplifier Type
Please specify which amplifier type is connected.
Surround amplifier Stereo amplifier
Proceed withBack with
Amplifier
Type
TV
loudspeakers
as centre
speaker
...
Sound com-
ponents
TV loudspeakers as centre speaker
Please specify whether you want to use your built-in TV speakers as active
centre speakers of your multi-channel speaker system. If so, connect the
centre output (pre-amplifier output, not speaker output) of the HiFi/AV
amplifier to the CENTER IN socket.
Finish wizard with
Back with
No yes