User guide

Connection Detail - Switch Voltage and Supply Voltage are different,
Say mains supply and switching 48 Volts AC from a transformer
*If a switch is not used, its input must still be wired, otherwise if its corresponding Transmitter Function is operated in error the Receiver will immediately switch off.
NOTE Operating when the switched Voltage is at low as 48 Volts,
the LED’s will be very dim!
F1 Safety
F1 Switch
F2 Safety
F2 Switch
F3 Safety
F3 Switch
F4 Safety
F4 Switch
M Safety
M Switch
Power Supply
90 - 264 VAC
for control circuits
ST -
LK1
LK2
RS232
ANT
Radio Module
Internal Aerial
glue
Wire is not supplied with Lodar 96 and 97 Series systems, local wiring regulations apply
48 Volts AC
from transformer Secondary Common Live
Output 1
Output 2 Output 3
Master Output
Primary power supply Earth Live (Hot) Neutral Secondary Neutral 48 Volts AC
from transformer required for safety circuit
Common Live Loop Important ALL inputs must
be wired *see note below