Installation Instructions

Tools Typically Required:
Utility knife, caulking gun.
Safety Precautions:
Wash hands after use.
Preparation:
The temperature of the product, the surfaces and the working area must be above 50°F (10°C). For best performance, apply
adhesive at 70°F (21°C). Ensure surfaces to be bonded are clean, dry, structurally sound and free of dust, grease, oil, and other
foreign contaminants. Sand glossy surfaces. Pre-cut and fit materials before applying adhesive. To open the container, tear the
black strip off of the red area marked “OPEN”. Pull off red cap from nozzle and turn the nozzle clockwise 180°. Slide the red tab
marked “OPEN” from left to right regulate the flow. Sliding the tab all the way to the right will deliver the maximum amount of flow
and all the way to the left will close the dispenser.
Application:
To dispense product, press the red lever. Apply adhesive around perimeter of large items approximately 2” from the edge, apply
additional beads at 6” intervals. Join substrates within 15 minutes and press firmly. Repositionable for 15 minutes. Achieves final
strength in 24 hours and full cure in up to 14 days. Temperature, humidity, substrate porosity and amount of adhesive used will
affect cure times.
Clean-up:
Clean tools and uncured adhesive residue immediately with warm water and soap. Cured adhesive may be carefully cut away with a
sharp-edged tool.