Installation Instructions

Tools Typically Required:
Tissue paper
Safety Precautions:
Well-ventilated area, gloves.
Preparation:
Surfaces must be clean, dry and free from oil, wax and paint. Protect work area. For better adhesion, lightly roughen smooth
surfaces. Pre-fit parts to be joined.
Application:
To open the adhesive tube: Screw the cap and nozzle clockwise all the way down to tube shoulder, puncturing the tube. Unscrew
the cap counter clockwise from the nozzle.
To open the activator: Pull top off black base, exposing felt tip applicator.
Note: The activator is only recommended for difficult to bond substrates such as polyethylene, polypropylene,
polytetrafluoroethylene (PTFE) and thermoplastic rubber materials. Other substrates do not require activator. Apply the surface
activator to both surfaces (see note above). Wait 60 seconds for the activator to completely dry. Apply the adhesive sparingly
to one side only using approximately one drop per square inch of surface. Press parts together immediately. Hold in place for 30
seconds or until bond sets. Do not reposition parts. Clean tip with tissue and replace the cap.
Clean-up
After cleaning, wet any tissue used for wiping off glue with water and dispose of. When cleaning up larger quantities of uncured
adhesive, apply water and allow to cure and then scrape up. Note this may result in damage to the surfaces. Cured adhesive may
be cut away with caution using a sharp blade, removed with acetone or with boiling water. Note: Acetone may damage some
plastics and is also highly flammable. Test before use and follow manufacturer’s instructions.