Safety Data Sheets (SDS)

ManualsBrandsLoctite ManualsBuilding materials12 oz. Tite Foam Big Gaps Insulating Foam Sealant (12-Pack)

IDH number: 2378565

Product name: LOC TITEFOAM Big Gaps 12OZ12SC

Page 3 of 6

7. HANDLING AND STORAGE

Handling:

Keep aw ay from heat, spark and flame. Do not puncture or incinerate

pressurized containers. Ensure adequate ventilation, especially in confined

areas. Prevent contact w ith eyes, skin and clothing. Do not breathe vapor and

mist. Wash thoroughly after handling. Keep out of the reach of children. When

using do not eat, drink or smoke. Wear suitable protective clothing, gloves and

eye/face protection. Refer to Section 8.

Storage:

Store betw een 50°F and 80°F. (10° and 27°C) Store aw ay from heat, sparks,

flames, or other sources of ignition. Do not store above 49 ºC (120 ºF). Do not

cut or w eld container.

For information on product shelf life, please review labels on container or check the Technical Data Sheet.

8. EXPOSURE CONTROLS / PERSONAL PROTECTION

Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper

exposure controls and protective equipment for each task performed.

Hazardous Component(s)

ACGIH TLV

OSHA PEL

AIHA WEEL

OTHER

Methylenebis(phenylisocyanate)

0.005 ppm TWA

0.02 ppm (0.2

mg/m3) Ceiling

None

dimethyl ether

None

1,000 ppm (1,880

mg/m3) TWA

None

Isobutane

1,000 ppm STEL

(Simple asphyxiant.)

None

propane

D: Simple

asphyxiant, EX:

Explosion hazard

(Simple asphyxiant.)

1,000 ppm (1,800

mg/m3) PEL

None

butane

1,000 ppm STEL

(Simple asphyxiant.)

None

Polyurethane prepolymer

None

Engineering controls:

Persons w ith asthmatic-type conditions, chronic bronchitis, other chronic

respiratory diseases or recurrent skin eczema or sensitization should be

excluded from w orking with isocyanates. Provide adequate local exhaust

ventilation to maintain w orker exposure below exposure limits.

Respiratory protection:

In case of insufficient ventilation w ear suitable respiratory equipment.

Eye/face protection:

Wear safety glasses with side shields.

Skin protection:

Rubber gloves recommended. Suitable protective clothing

9. PHYSICAL AND CHEMICAL PROPERTIES

Physical state:

Aerosol

Color:

Yellow -white

Odor:

slightly, of ether

Odor threshold:

Not available.

pH:

Not available.

Vapor pressure:

> 100 mm hg (20 °C (68°F))

Boiling point/range:

-42 °C (-43.6 °F)Compressed Gas.

Melting point/ range:

Not available.

Specific gravity:

1.107

Vapor density:

< 1 (Air = 1)

Flash point:

-104 °C (-155.2 °F)

Flammable/Explosive limits - lower:

0.4 % The product is not explosive. The formation of explosive vapor/air

mixtures is possible.

Flammable/Explosive limits - upper:

32 % The product is not explosive. The formation of explosive vapor/air

mixtures is possible.

Autoignition temperature:

Not available.

Flammability:

Extremely flammable aerosol.

Evaporation rate:

10 (Butyl acetate = 1)

Solubility in water:

Reacts slow ly with water to liberate carbon dioxide gas.

Partition coefficient (n-octanol/water):

Not available.

VOC content:

19.28 %; 208.6 g/l (by w eight, calculated using CARB method; g/L less w ater,

less exempts calculated using SCAQMD method)

Viscosity:

Not available.