Safety data sheet

MSDS-No.: 153750
V003.2
LOCTITE LB 8012 LOW FRICTION LUBRICANT known as Moly Paste
Page 2 of 7
Declaration of the ingredients according to CLP (EC) No 1272/2008:
Contains no dangerous substances exceeding the limits of the EU-Regulation
SECTION 4: First aid measures
4.1. Description of first aid measures
Inhalation:
Move to fresh air. If symptoms persist, seek medical advice.
Skin contact:
Rinse with running water and soap.
Obtain medical attention if irritation persists.
Eye contact:
Rinse immediately with plenty of running water (for 10 minutes), seek medical attention from a specialist.
Ingestion:
Rinse mouth, drink 1-2 glasses of water, do not induce vomiting, consult a doctor.
4.2. Most important symptoms and effects, both acute and delayed
Prolonged or repeated contact may cause skin irritation.
Prolonged or repeated contact may cause eye irritation.
4.3. Indication of any immediate medical attention and special treatment needed
See section: Description of first aid measures
SECTION 5: Firefighting measures
5.1. Extinguishing media
Suitable extinguishing media:
Carbon dioxide, foam, powder
Extinguishing media which must not be used for safety reasons:
High pressure waterjet
5.2. Special hazards arising from the substance or mixture
In the event of a fire, carbon monoxide (CO) and carbon dioxide (CO2) can be released.
Oxides of carbon, oxides of nitrogen, irritating organic vapors.
5.3. Advice for firefighters
Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear.
Additional information:
In case of fire, keep containers cool with water spray.
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Avoid skin and eye contact.
Ensure adequate ventilation.
6.2. Environmental precautions
Do not empty into drains / surface water / ground water.
6.3. Methods and material for containment and cleaning up
For small spills wipe up with paper towel and place in container for disposal.
For large spills absorb onto inert absorbent material and place in sealed container for disposal.
Dispose of contaminated material as waste according to Section 13.