SDS

IDH number: 1381191
Product name: Loctite® Naval Jelly® Rust Dissolver
Page 2 of 7
3. COMPOSITION / INFORMATION ON INGREDIENTS
Hazardous Component(s)
CAS Number
Percentage*
Phosphoric acid
7664-38-2
10 - 30
2-Propanol
67-63-0
1 - 5
Xanthan gum
11138-66-2
1 - 5
Sulfuric acid
7664-93-9
0.1 - 1
Silica, amorphous, fumed, crystal-free
112945-52-5
0.1 - 1
Diiron trioxide
1309-37-1
0.1 - 1
Magnesium oxide
1309-48-4
0.1 - 1
Aluminium oxide
1344-28-1
0.1 - 1
Alcohols, C11-14-iso-, C13 rich, EO~
78330-21-9
0.1 - 1
* Exact percentage is a trade secret. Concentration range is provided to assist users in providing appropriate protections.
4. FIRST AID MEASURES
Inhalation:
Move to fresh air. If not breathing, give artificial respiration. If breathing is
difficult, give oxygen. Get medical attention.
Skin contact:
Immediately flush skin with plenty of water (using soap, if available). Remove
contaminated clothing and footwear. Wash clothing before reuse. Get medical
attention.
Eye contact:
Rinse immediately with plenty of water, also under the eyelids, for at least 15
minutes. Get medical attention.
Ingestion:
DO NOT induce vomiting unless directed to do so by medical personnel.
Never give anything by mouth to an unconscious person. Get medical
attention.
Symptoms:
See Section 11.
5. FIRE FIGHTING MEASURES
Extinguishing media:
Foam, dry chemical or carbon dioxide.
Special firefighting procedures:
Wear self-contained breathing apparatus and full protective clothing, such as
turn-out gear. In case of fire, keep containers cool with water spray.
Unusual fire or explosion hazards:
Not flammable, however Hydrogen gas may be liberated if product contacts
powdered metals or metals above 185°F.
Hazardous combustion products:
Hydrogen.
6. ACCIDENTAL RELEASE MEASURES
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected
personnel.
Environmental precautions:
Do not allow product to enter sewer or waterways.
Clean-up methods:
Remove all sources of ignition. Evacuate and ventilate spill area; dike spill to
prevent entry into water system; wear full protective equipment during clean-
up. Soak up with inert absorbent material (e.g. sand, silica gel, acid binder,
universal binder, sawdust). Scrape up as much material as possible. Store in a
partly filled, closed container until disposal. Flush with water. Neutralize acid
using lime or a lime based agent compatible with the product. Refer to Section
8 "Exposure Controls / Personal Protection" prior to clean up.