Safety data sheet

MSDS-No.: 326229
V005.0
LOCTITE SF 7900 AE 400ML
Page 10 of 18
Respiratory protection:
In case of aerosol formation, we recommend wearing of appropriate respiratory protection equipment with ABEK P2 filter (EN
14387).
This recommendation should be matched to local conditions.
Hand protection:
Chemical-resistant protective gloves (EN 374). Suitable materials for short-term contact or splashes (recommended: at least
protection index 2, corresponding to > 30 minutes permeation time as per EN 374): Isobutylene-isoprene rubber (IIR; >= 0.7 mm
thickness) Suitable materials for longer, direct contact (recommended: protection index 6, corresponding to > 480 minutes
permeation time as per EN 374): Isobutylene-isoprene rubber (IIR; >= 0.7 mm thickness) This information is based on literature
references and on information provided by glove manufacturers, or is derived by analogy with similar substances. Please note
that in practice the working life of chemical-resistant protective gloves may be considerably shorter than the permeation time
determined in accordance with EN 374 as a result of the many influencing factors (e.g. temperature). If signs of wear and tear are
noticed then the gloves should be replaced.
Eye protection:
Protective goggles
Protective eye equipment should conform to EN166.
Skin protection:
Suitable protective clothing
Protective clothing should conform to EN 14605 for liquid splashes or to EN 13982 for dusts.
Advices to personal protection equipment:
The information provided on personal protective equipment is for guidance purposes only. A full risk assessment should be
conducted prior to using this product to determine the appropriate personal protective equipment to suit local conditions.
Personal protective equipment should conform to the relevant EN standard.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Appearance
aerosol
liquid
Off white
Odor
Acetone
Odour threshold
No data available / Not applicable
pH
Not applicable
pH
Not applicable
Melting point
No data available / Not applicable
Solidification temperature
No data available / Not applicable
Initial boiling point
56 °C (132.8 °F)
Flash point
-20 °C (-4 °F)Solvent Mixtures
Evaporation rate
No data available / Not applicable
Flammability
No data available / Not applicable
Explosive limits
lower
upper
1,8 %(V)
13,0 %(V)
Vapour pressure
(50 °C (122 °F))
764 mbar
Vapour pressure
(55 °C (131 °F))
961 mbar
Relative vapour density:
No data available / Not applicable
Density
()
0,8 g/cm3
Bulk density
No data available / Not applicable
Solubility
No data available / Not applicable
Solubility (qualitative)
Soluble
Partition coefficient: n-octanol/water
No data available / Not applicable
Auto-ignition temperature
No data available / Not applicable
Decomposition temperature
No data available / Not applicable
Viscosity
()
Not determined