Safety data sheet

SDS No.: 283267 V007.0
LOCTITE LB 8156 known as Loctite 8156 500g EGFD
Page 4 of 9
7.3. Specific end use(s)
Lubricant
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Occupational Exposure Limits
Valid for
Great Britain
None
Occupational Exposure Limits
Valid for
Ireland
None
Biological Exposure Indices:
None
8.2. Exposure controls:
Engineering controls:
Ensure good ventilation/extraction.
Respiratory protection:
Use only in well-ventilated areas.
Use filter A-P2 if vapours/aerosols occur which may be inhaled.
Hand protection:
Chemical-resistant protective gloves (EN 374).
Suitable materials for short-term contact or splashes (recommended: at least protection index 2, corresponding to > 30 minutes
permeation time as per EN 374):
nitrile rubber (NBR; >= 0.4 mm thickness)
Suitable materials for longer, direct contact (recommended: protection index 6, corresponding to > 480 minutes permeation time
as per EN 374):
nitrile rubber (NBR; >= 0.4 mm thickness)
This information is based on literature references and on information provided by glove manufacturers, or is derived by analogy
with similar substances. Please note that in practice the working life of chemical-resistant protective gloves may be considerably
shorter than the permeation time determined in accordance with EN 374 as a result of the many influencing factors (e.g.
temperature). If signs of wear and tear are noticed then the gloves should be replaced.
Eye protection:
Safety glasses with sideshields or chemical safety goggles should be worn if there is a risk of splashing.
Protective eye equipment should conform to EN166.
Skin protection:
Wear suitable protective clothing.
Protective clothing should conform to EN 14605 for liquid splashes or to EN 13982 for dusts.
Advices to personal protection equipment:
The information provided on personal protective equipment is for guidance purposes only. A full risk assessment should be
conducted prior to using this product to determine the appropriate personal protective equipment to suit local conditions.
Personal protective equipment should conform to the relevant EN standard.