Certifications 2

MSDS-No.: 280434
V005.0
LOCTITE LB 8151 known as Loctite 8151
Page 6 of 12
Respiratory protection:
Do not inhale vapors and fumes.
Use only in well-ventilated areas.
An approved mask or respirator fitted with an organic vapour cartridge should be worn if the product is used in a poorly
ventilated area
Filter type: A (EN 14387)
Hand protection:
Chemical-resistant protective gloves (EN 374).
Suitable materials for short-term contact or splashes (recommended: at least protection index 2, corresponding to > 30 minutes
permeation time as per EN 374):
nitrile rubber (NBR; >= 0.4 mm thickness)
Suitable materials for longer, direct contact (recommended: protection index 6, corresponding to > 480 minutes permeation time
as per EN 374):
nitrile rubber (NBR; >= 0.4 mm thickness)
This information is based on literature references and on information provided by glove manufacturers, or is derived by analogy
with similar substances. Please note that in practice the working life of chemical-resistant protective gloves may be considerably
shorter than the permeation time determined in accordance with EN 374 as a result of the many influencing factors (e.g.
temperature). If signs of wear and tear are noticed then the gloves should be replaced.
Eye protection:
Wear protective glasses.
Protective eye equipment should conform to EN166.
Skin protection:
Suitable protective clothing
Protective clothing should conform to EN 14605 for liquid splashes or to EN 13982 for dusts.
Advices to personal protection equipment:
The information provided on personal protective equipment is for guidance purposes only. A full risk assessment should be
conducted prior to using this product to determine the appropriate personal protective equipment to suit local conditions.
Personal protective equipment should conform to the relevant EN standard.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Appearance
aerosol
grey
Odor
characteristic
Odour threshold
No data available / Not applicable
pH
No data available / Not applicable
Initial boiling point
0 °C (32 °F)
Flash point
-60 °C (-76 °F)
Decomposition temperature
No data available / Not applicable
Vapour pressure
(20 °C (68 °F))
3000 mbar
Density
(20 °C (68 °F))
0,692 g/cm3
Bulk density
No data available / Not applicable
Viscosity
No data available / Not applicable
Viscosity (kinematic)
No data available / Not applicable
Explosive properties
No data available / Not applicable
Solubility (qualitative)
(Solvent: Water)
Not miscible
Solidification temperature
No data available / Not applicable
Melting point
No data available / Not applicable
Flammability
No data available / Not applicable
Auto-ignition temperature
No data available / Not applicable
Explosive limits
lower
upper
0,7 %(V)
8,5 %(V)