Certifications 2

SDS No.: 153749 V004.1
LOCTITE LB 8009
Page 5 of 12
Distillates (petroleum), hydrotreated light
naphthenic < 3% DMSO
64742-53-6
[MINERAL OIL, PURE, HIGHLY &
SEVERELY REFINED, INHALABLE
FRACTION]
5
Time Weighted Average
(TWA):
IR_OEL
Predicted No-Effect Concentration (PNEC):
Name on list
Environmental
Compartment
Exposure
period
Value
Remarks
mg/l
ppm
mg/kg
others
Calcium fluoride
7789-75-5
aqua
(freshwater)
0,9 mg/l
Calcium fluoride
7789-75-5
sewage
treatment plant
(STP)
51 mg/l
Calcium fluoride
7789-75-5
Soil
11 mg/kg
Distillates (petroleum), hydrotreated light
naphthenic < 3% DMSO
64742-53-6
oral
9,33 mg/kg
Derived No-Effect Level (DNEL):
Name on list
Application
Area
Route of
Exposure
Health Effect
Exposure
Time
Value
Remarks
Calcium fluoride
7789-75-5
Workers
inhalation
Long term
exposure -
systemic effects
5 mg/m3
Calcium fluoride
7789-75-5
General
population
inhalation
Long term
exposure -
systemic effects
0,5 mg/m3
Calcium fluoride
7789-75-5
General
population
oral
Long term
exposure -
systemic effects
0,02 mg/kg
Biological Exposure Indices:
None
8.2. Exposure controls:
Engineering controls:
Ensure good ventilation/extraction.
Respiratory protection:
Use only in well-ventilated areas.
An approved mask or respirator fitted with an organic vapour cartridge should be worn if the product is used in a poorly
ventilated area
Filter type: A (EN 14387)
Hand protection:
Chemical-resistant protective gloves (EN 374).
Suitable materials for short-term contact or splashes (recommended: at least protection index 2, corresponding to > 30 minutes
permeation time as per EN 374):
nitrile rubber (NBR; >= 0.4 mm thickness)
Suitable materials for longer, direct contact (recommended: protection index 6, corresponding to > 480 minutes permeation time
as per EN 374):
nitrile rubber (NBR; >= 0.4 mm thickness)
This information is based on literature references and on information provided by glove manufacturers, or is derived by analogy
with similar substances. Please note that in practice the working life of chemical-resistant protective gloves may be considerably
shorter than the permeation time determined in accordance with EN 374 as a result of the many influencing factors (e.g.
temperature). If signs of wear and tear are noticed then the gloves should be replaced.