Certifications 2

SDS No.: 153750 V004.0
LOCTITE LB 8012 known as Loctite 8012 Moly EDFN_SFDN
Page 5 of 10
Biological Exposure Indices:
8.2. Exposure controls:
Engineering controls:
Ensure good ventilation/extraction.
Respiratory protection:
Ensure adequate ventilation.
An approved mask or respirator fitted with an organic vapour cartridge should be worn if the product is used in a poorly
ventilated area
Filter type: A (EN 14387)
Hand protection:
Chemical-resistant protective gloves (EN 374).
Suitable materials for short-term contact or splashes (recommended: at least protection index 2, corresponding to > 30 minutes
permeation time as per EN 374):
nitrile rubber (NBR; >= 0.4 mm thickness)
Suitable materials for longer, direct contact (recommended: protection index 6, corresponding to > 480 minutes permeation time
as per EN 374):
nitrile rubber (NBR; >= 0.4 mm thickness)
This information is based on literature references and on information provided by glove manufacturers, or is derived by analogy
with similar substances. Please note that in practice the working life of chemical-resistant protective gloves may be considerably
shorter than the permeation time determined in accordance with EN 374 as a result of the many influencing factors (e.g.
temperature). If signs of wear and tear are noticed then the gloves should be replaced.
Eye protection:
Wear protective glasses.
Protective eye equipment should conform to EN166.
Skin protection:
Wear suitable protective clothing.
Protective clothing should conform to EN 14605 for liquid splashes or to EN 13982 for dusts.
Advices to personal protection equipment:
The information provided on personal protective equipment is for guidance purposes only. A full risk assessment should be
conducted prior to using this product to determine the appropriate personal protective equipment to suit local conditions.
Personal protective equipment should conform to the relevant EN standard.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Appearance
paste
grey
Odor
mild
Odour threshold
No data available / Not applicable
pH
Not applicable
Melting point
No data available / Not applicable
Solidification temperature
No data available / Not applicable
Initial boiling point
No data available / Not applicable
Flash point
160 °C (320 °F)
Evaporation rate
No data available / Not applicable
Flammability
No data available / Not applicable
Explosive limits
No data available / Not applicable
Vapour pressure
No data available / Not applicable
Relative vapour density:
No data available / Not applicable
Density
()
1,9614 g/cm3
Bulk density
No data available / Not applicable