Instructions / Assembly
14
3. Ensure a
minimum of 24
inches (61 cm)
separate the
LP tank and the
appliance.
4. Open the LP tank valve fully by turning
counterclockwise.
5. Electronic Ignitor
Lighting: Press
and continually hold
the ignition button
while rotating the
regulator control knob
clockwise until the burner is lit. DO NOT
stand with head or arms over burner.
Match Lighting:
Using a long
ignited match
(replace match),
place ame
directly over the
burner. If using
a short/paper book match, rst place the
unlit match into the match holder which is
attached by a chain to the boiler stand, then
light the match. DO NOT stand with head or
arms over burner. Slowly turn the regulator
control knob clockwise until burner is lit.
6. When the burner is lit, turn the regulator
control knob to the desired heat output
position between ON and OFF.
BURNER FLAME CHECK
Light the burner and adjust the ame with the
regulator control knob. Always check the ame
prior to each use. A blue ame with little or no
yellow ame will provide the best heat.
WHEN BURNER FLAME IS ACCIDENTALLY
EXTINGUISHED:
1. Turn LP tank OFF by turning hand wheel
clockwise to a full stop.
2. Turn regulator control knob
counterclockwise to the OFF position.
3. Inspect the hose and make sure
connections are complete. After waiting
5 minutes, restart the appliance following
“INSTRUCTIONS FOR LIGHTING
BURNER.”
SHUT DOWN INSTRUCTIONS:
1. Turn LP tank OFF by turning hand wheel
clockwise to a full stop.
2. Turn regulator control knob
counterclockwise to the OFF position.
OPERATING INSTRUCTIONS
LP hose is a tripping hazard.
Special Care must be observed.
WARNING
If ignition does not occur in 5 seconds,
turn the regulator control knob OFF, wait 5
minutes, then repeat the lighting procedure.
If the burner does not light with the regulator
control knob on, or if the ame goes out after
lighting, gas will continue to ow out of the
burner and could accidentally ignite with risk
of injury.
CAUTION
Burner
Correct Incorrect
Yellow ame
Blue ame
Yellow ame
Blue ame
Burner
Match Holder