Operating Guide

To lock the SafeCase

, close the door and then press the Start but-

ton. The unit will then lock.

LOCKING THE SafeCase

Your SafeCase

comes with a security cable that can affix the unit

to a permanent object and render the unit immobile. To secure the

SafeCase

follow these steps:

3. Wrap the security cable around a permanent object much in the

way a bicycle lock works. (see figure 3)

1. Thread one end of the security cable through the eye of the

other

2. With the SafeCase

open, place the unthreaded end of the ca-

ble through the space in the SafeCase

. Make sure to place the

metal stopper on the inside of the SafeCase

in order to secure the

cable.

Close and lock the SafeCase

ACCESSORIES

CHANGING THE BATTERIES

When turning on the SafeCase

if the LED flashes red and green and

beeps 3 times, the batteries are low and need changing.

To change the batteries, follow these steps:

1. Pull off the battery cover located inside the SafeCase

right next to the

sensor. (see figure 2).

2. Take out the rectangular battery case by pulling on the ribbon.

3. Replace all old batteries with fresh batteries. Follow the “+” and “-“

signs to properly insert the new batteries.

Replace the battery case and snap the cover back in place.

Figure 2

Figure 3

6 7