Operating Guide

1. Press and hold the Add/Delete and Start buttons simultaneously for 2

seconds. You will see the LED flash red.

2. Continue to hold the Add/Delete and Start buttons for an additional 10

seconds. You will see the LED turn green as the sensor deletes ALL users.

***THE SafeCase

CANNOT DELETE INDIVIDUAL USERS. THIS

PROCESS WILL DELETE ALL USERS IN THE SYSTEM.

3. After holding for 10 seconds, release all buttons. The unit will now

power off indicating that all users have been deleted.

***UNTILL NEW USERS HAVE BEEN ENROLLED, TO NOW UNLOCK

AND LOCK THE UNIT, SIMPLY PRESS THE START BUTTON

DELETING ALL USERS

Fingerprint Access

1. Press the start button (see figure 1) until the LED flashes green and the

sensor beeps once.

2. Place and hold your finger on the sensor with your fingertip at the top for

2 seconds.

3. Make sure that your finger lays flat and even over the sensor. Slowly

swipe your finger from top to bottom, taking 2 seconds to complete the

swipe. Move your entire finger across the sensor.

4. When the sensor detects a fingerprint that has been enrolled, you will

hear a beep as the LED light turns off and the SafeCase

unlocks allow-

ing you to open the unit.

If when swiping your finger, the sensor does NOT accept your fingerprint,

the LED will flash red and the unit will remain locked. If the unit does not

unlock after several attempts swiping your finger, delete all users and go

through the enrollment process again.

Override Key Access

You can also access the SafeCase

with the override key by following these

steps:

1. Insert the override key into the lock at the front of the SafeCase

2. Turn the key clockwise to unlock the unit

3. Open the unit

To re-lock the SafeCase

after accessing by override key, follow these steps:

1. Leave the key in the lock until you are ready to re-lock the unit.

2. Close the SafeCase

and turn the key counterclockwise then remove the

key.

Press the Start button to lock the unit.

OPENING THE SafeCase

4 5