Instruction Manual

1
OPERATING INSTRUCTIONS FOR
D2 LOCKING BASIC VERSION
MODE: D2 SMALL SCREEN + FINGERPRINT HEAD
M4*8+字沉头螺丝(2个)
M6 * 50 + countersunk head screws (2)
M6 * 50 + countersunk
head screws (2)
St3.5 * 20 + countersunk head
tapping screws (2)
St3.5 * 20 + countersunk head
tapping screws (2)
Interior Assembly
Mounting Plate
Touch Keypad Assembly
Deadbolt Strike plate
Buckle box
Deadbolt Latch
Entry Key
(2 ea.)
2
Cross countersunk head
Cross countersunk head
Install the latch and strike
1. Insert the latch bolt into the door.
2. Install strike on the door frame.
Twist the latch and adjust the bolt length.
(Make sure the latch bolt is retracted).
up
YES
up
NO
Make sure the
is in the bottom position.
T-shaped hole
No adjustment is required.
Proceed to next step.
Make sure the hole in the door
frame is drilled a minimum of
1"(25mm)deep.
YES
NO
NO
up
St3.5 * 20s cross countersunk
head tapping screw
St3.5 * 20s cross countersunk
head tapping screw
3
Install the interior assembly
2. Route cable through the
bottom of mouting plate.
1. Take off the mounting plate.
4. Ensure tight cable connection.
3. Tighten screws evenly.
5. Tighten screws evenly.
Note:
please support
exterior assembly
during mounting
plate installation.
Insert key and test latch.
if latch does not extend or retract smoothly.
please adjust mounting plate screws.
If the keypad and mounting plate are
deflection.
please loose mounting plate screws
and adjust.
NO NO
Mounting plate
The smooth side of
the plug should be at the bottom.
4

Summary of content (4 pages)