Full Product Manual

SECTION 2.6
7
2.6 Low Battery
When the battery is in seriously low condition, Lockly will make continuous beeping
sounds in addition to the flashing low battery icon on the touch screen. You should replace
batteries immediately to avoid your smart lock from shutting down.
When your smart lock low-battery warning alert finally dies, video doorbell and recording
will be disabled. You will have few more chances to unlock your smart lock either by a
password, Lockly APP or fingerprint. If the unlock was successful, the low-battery warning
alert will be on for 1 minute. After which, the smart lock will go to dead-battery mode
and will lock auto lock in 5 seconds and the screen will display a low-battery icon.
Dead Battery
Condition Indicator Solution
Low Battery
Battery Icon on the display
keypad will light up to indicate
low battery.
Replace batteries immediately
to avoid battery failure. Lockly
Vision can still operate up to 50
cycles in low battery condition.
When there is no display and
sounds; and screen is non-functional.
Replace batteries immediately.
Supplied physical backup keys
can be used to unlock the door.
Alternatively, use a 9V battery
as shown below to temporarily
activate the lock.
Your Lockly will automatically detect battery
polarity. So hold your 9V battery lead in
place against bottom of the Lockly to
temporarily activate the screen to enter
your Access Code. Be sure to hold the 9V
battery against the contact points located
at the bottom of the lock until you have
successfully unlocked your door with your
Access Code. Once unlocked, batteries
should be replaced immediately.
9V Battery
-
+