Full Product Manual

Like other digital electronic products water can trigger to activate the touchscreen and

fingerprint sensor which may cause the batteries to drain. To protect the lock and extend

battery life, you can setup your Lockly to enter Rain Mode to shut off keypad and fingerprint

reader whenever rain or water is detected.

Activate this feature on the Lockly app. While you are within the Bluetooth range or

remotely connected thru Wi-Fi hub (Secure Link), go to Settings > Rain Mode and toggle

the button to turn ON.

If you have not yet connected your device to Lockly App, follow below steps to activate

the rain mode feature:

To reactivate fingerprint and keypad access when

your lock has entered rain mode, turn the key cover.

When RAIN MODE is ON, the keypad and fingerprint

sensor cannot be used. Unlock via Lockly App,

physical key, or voice with your Amazon Alexa or

Google Assistant-enabled devices. Rain Mode auto

exits every 30-mins and re-enters if water or rain is still

present.

If you are using the Lockly app, you will be notified

when Lockly entered rain mode and it will be recorded

in your access history.

RAIN MODE ON

1. Long press to enter fixed digit keypad.

Enter

access code +234+ .

3. You will hear a short beep and Bluetooth

indicator flashes green once Rain Mode is ON.

RAIN MODE OFF

1. Long press to enter fixed digit keypad.

2. Enter access code +890+ .

3. You will hear a long beep and Bluetooth

indicator flashes green once Rain Mode is OFF.

example: 135790 + 234 +

example: 135790 + 890 +

IMPORTANT

4.7 Rain Mode

SECTION 4.7