Installation Guide

STEP 8: INSTALLING BATTERIES

First install 3 of the 4 batteries. Before installing the

last battery, press and hold the PROGRAM button

while installing the last battery until you hear a

beep from Lockly

Lockly

will then perform a self check and the

keypad

screen will start to initiate. This self check will

automatically

determine and set your door lock to a

left open or right open door.

The self-check process is very important step to ensure the installation is done properly.

After the lock finished the self-check, manually lock and and unlock your door by using the

thumb turn and the key to make sure the deadbolt moves smoothly. If you feel that there is

a tight tension while you are turning, it means that the lock may have not been installed

straight. Go back to Step 2 and re-install the lock.

To check if your lock was installed correctly, manually unlock your door by using the thumb

turn, then brush your hand across the screen on the outside. Your lock should lock the dead

bolt. If your lock automatically unlocks after it has been locked, it means that your lock was

installed incorrectly - proceed to Step 2 to make sure your lock was installed with the dead

bolt extended and the torque blade was inserted vertically while the dead bolt was extended.