Installation Guide

3: Once self-check completes ensure the lock operates smoothly by manually locking and unlocking

the door using the thumb turn on the interior assembly. The deadbolt should operate smoothly

without any interference or binding. If necessary, repeat step 2 and ensure that (a) the deadbolt

was extended and (b) the torque blade was inserted vertically while the deadbolt was extended.

Swipe your hand across touchscreen. The lock should

close (lock). If the touchscreen is ON, touch , the

lock should lock as well. If deadbolt bounces back or

unlocks automatically it means something is not installed

correctly. Go back and repeat step 2, same as above.

5: Once self-check is complete, install battery cover

(H), secure with screw on top (do not over tighten).

With door open and deadbolt fully extended, place

ribbon inside compartment and insert 4 batteries (note

correct -/+ polarity).

2: After all batteries are installed, PRESS and HOLD the

program button for 10S. The lock will automatically start

self-check (release program button once check starts).

The self-check process determines right or left swinging

door and is very important to ensure correct installation.

IMPORTANT: if lock is not properly installed it will open

and close repeatedly.

INSTALLING BATTERIES

Step 4

PRESS

& HOLD