Full Product Manual

30 SECTION 4.8
Like other digital electronic products water can trigger to activate the touchscreen and fingerprint
sensor which may cause the batteries to drain. To protect the lock and extend battery life, you can
setup your Lockly to enter Rain Mode to shut off keypad and fingerprint reader whenever rain or water
is detected.
Activate this feature on the Lockly app. While you are within the Bluetooth range or remotely connected
thru Wi-Fi hub (Secure Link), go to Settings > Rain Mode and toggle the button to turn ON.
If you have not yet connected your device to Lockly App,
follow below steps to activate the rain mode feature:
When RAIN MODE is ON, the keypad and
fingerprint sensor cannot be used. Unlock via
Lockly App, physical key, or voice control
with Amazon Alexa or Google Assistant-
enabled devices. Rain Mode auto exits
every 30-mins and re-enters if water or rain
is still present.
If you are using the Lockly app, you will be
notified when Lockly entered rain mode and
it will be recorded in your access history.
4.8 Rain Mode
IMPORTANT
RAIN MODE ON
1. Long press to enter fixed digit keypad.
2. Enter access code +234+ .
3. You will hear a short beep and Bluetooth
indicator flashes green once Rain Mode is ON.
RAIN MODE OFF
1. Long press to enter fixed digit keypad.
2. Enter access code +890+ .
3. You will hear a long beep and Bluetooth
indicator flashes green once Rain Mode is OFF.
example: 135790 + 234 +
example: 135790 + 890 +