Full Product Manual

SECTION 3.6

3.6 Adding a Fingerprint (Continued)

NOTICE

Please make sure your fingers are clean from dirt and oils before scanning

your fingerprint. Make sure the sensor is also clean by taking a soft cloth

and wiping the surface.

Scan your finger by lightly placing your designated finger on the sensor until you hear a beep. Lift your

finger and repeat the process slowly until the digit “6” shown on the screen becomes “1”. If you have

successfully scanned and registered your fingerprint, you will hear a long beep, and the Bluetooth icon

will

flash green.

PASS will show on the keypad and press OK to exit. If you did not successfully register your fingerprint,

FAIL will show on the keypad. If FAIL is displayed, press OK to return to the previous screen to rescan

your finger.

For instructions on scanning an optimal fingerprint, please proceed to Section 3.7.

OK Button