Manualshelf

Full Product Manual

ManualsBrandsLockly ManualsSmart HomeSecure Plus Matte Black Single-Cylinder Smart Alarmed Lock Latch with Keypad, Bluetooth and Fingerprint
11121314151617181920
SECTION 3.6 17
3.6 Adding a Fingerprint (Continued)
While in Programming Mode, select
“1AD” to add an Access Code. If you
are not in Programming Mode, please
see Section 3.2 to enter Programming
Mode.
After pressing “1AD” press “FP” to
register
a Fingerprint.
Upon pressing “FP”, you will enter Fingerprint Registration Mode and you will see a green LED ring light
up
on the fingerprint panel on the exterior side of Lockly Secure Plus / Pro.
Once you’re in Fingerprint Registration Mode you will see two numbers
displayed on keypad. The top number is your Fingerprint Registration
number, in this example to the left, “1”. The bottom number will always
start with a “6”.
You must successfully scan your fingerprint six (6) times for it to properly
register. Every time you scan your fingerprint, the number on the
bottom will change, starting from 6 - then 5, 4, 3, 2, 1, until the
fingerprint is successfully registered.
Note: For reference, please keep a record of your fingerprint
registration
number to distinguish whom it was registered to.