Full Product Manual

SECTION 3.5 15
3.5 Checking the Access Codes
OK Button
While in Programming Mode, select “3CH”
to check registered Access Codes. If
you are not in Programming Mode, please
see Section 3.2 to enter Programming
Mode.
Active Access Codes will then be displayed
on the screen in sequence from left to
right, top to bottom. In the example
shown on the left, the Access Code
displayed is 1 3 5 7 9 0 .
Rotate through the different Access Codes by touching any number on the screen.
To exit Check Access Code screen, simply press the OK button.
If there are no Access Codes registered in your smart lock, Check Access
Code mode will be invalid. The default Access Code will not be shown
on the display keypad, and you will see the following screen shown to
the left instead.